South East Scoobies  

Go Back   South East Scoobies > The Garage > General Mechanics
Reload this Page Boiling up still
FAQ Calendar

Reply
 
Thread Tools
  #1  
Old 22-07-2013, 09:42 AM
Lucky's Avatar
Lucky Lucky is offline
'2 Spanners Qualified Technician' - If your job requires more then 1 spanner I'm your man !!!!!
  
Join Date: Sep 2008
Location: Telscombe Cliffs
Posts: 5,062
Default Boiling up still
I took the car for a 30 odd mile drive yesterday morning. It ran really well but when I got home and popped the bonnet the expansion tank had risen to the top ( usually about an inch in it) and was bubbling and I could hear the coolant boiling in the main header tank as well. Water temp gauge in car reads normal, fans work.

Its booked in to SMD on 8th August for a service and Brent is going to check hoses etc, BUT I really want to bring it up to Barcombe on 29th but not sure if I should be driving it while its getting this hot.

I am thinking It may be air in the system, how do I bleed it??

Alternatively could be thermostat? or a small split somewhere? or, of course head gasket but hoping not!!!

Any idea's would be appreciated.
__________________
10 Years of Scoobies:04 WRX SL, 06 HAWK STI, 97 JDM WRX STI WAGON, 05 WRX STI, MK3 FOCUS RS, now Porsche Cayman S
Reply With Quote
  #2  
Old 22-07-2013, 09:56 AM
RCS2810 RCS2810 is offline
BANNED USER
  
Join Date: Jun 2013
Location: Fuel Station
Posts: 330
Default
Hmm my knowledge is limited but I'll try to help .

Does the bottom hose get hot too? Any idea or receipts as to when the thermostat was last done?

I think the only way to bleed the system is take the cap off the header tank from cold, start it up and let it run all the air bubbles out.

As to the HG, have you checked usual things like blows hot air from vents? Checked if theres no gunk in oil and coolant is clean?

I'm sure someone will tell me what I've said is wrong lol.
Reply With Quote
  #3  
Old 22-07-2013, 10:05 AM
RCS2810 RCS2810 is offline
BANNED USER
  
Join Date: Jun 2013
Location: Fuel Station
Posts: 330
Default
Also have you checked the condition of the rad? May be damaged or blocked therefore not cooling.
Reply With Quote
  #4  
Old 22-07-2013, 10:09 AM
SpecB's Avatar
SpecB SpecB is offline
Moderator (formerly known as Bluebugeye!)
  
Join Date: Mar 2009
Location: Littlehampton
Posts: 4,345
Default
I had the same issue, thought it was HG but swapped the rad cap, all is good! Cap was not keeping the system pressurised enough and allowing coolant to boil.
__________________
2005 Spec B 6MT - KiDO tuned (~270Bhp)
Custom exhaust - Cosworth filter - Samco Intake - Tints - Bilstein B8/B6 & STI springs - SuperPro ALK - Whiteline positive shift kit, rack mounts, rear adjustable camber bushes, front ARB mounts & strut brace, 20mm rear ARB with AVO mounts, - Hardrace Gearbox and pitch mounts - Prodrive PFF7's - Front Brembos - Kenwood CarPlay - 1/2 carbon grille - STI front splitter
Reply With Quote
  #5  
Old 22-07-2013, 10:19 AM
Lucky's Avatar
Lucky Lucky is offline
'2 Spanners Qualified Technician' - If your job requires more then 1 spanner I'm your man !!!!!
  
Join Date: Sep 2008
Location: Telscombe Cliffs
Posts: 5,062
Default
I switched the cap a couple of weeks ago. The heater blows hot air, no wet carpets and the oil cap is clean. The coolant in the expansion tank is also clean.
__________________
10 Years of Scoobies:04 WRX SL, 06 HAWK STI, 97 JDM WRX STI WAGON, 05 WRX STI, MK3 FOCUS RS, now Porsche Cayman S
Reply With Quote
  #6  
Old 22-07-2013, 11:14 AM
RCS2810 RCS2810 is offline
BANNED USER
  
Join Date: Jun 2013
Location: Fuel Station
Posts: 330
Default
Whats about bottom hose? That can be a sign that the thermostat is stuck shut...
And checked the rad?
Reply With Quote
  #7  
Old 22-07-2013, 11:22 AM
NorthDownsScooby's Avatar
NorthDownsScooby NorthDownsScooby is offline
Bronze Member
  
Join Date: Aug 2009
Location: Liss, Hamps
Posts: 224
Default
Check & clean all the electrical connections in the system too......
__________________
ex Black 2006 Forester STI
SurreyScoobies Dude, Tent Pervert, Wannabe Ninja, General Nobber, Part Time Twat, Total Piss-Artiste.
Reply With Quote
  #8  
Old 22-07-2013, 11:34 AM
Anger's Avatar
Anger Anger is offline
Platinum Member
  
Join Date: Oct 2008
Location: Bletchingley Surrey
Posts: 4,973
Default
If the fans cut in its not normally a blockage
__________________
"We're here for a good time, not a long time...." Colin McRae MBE 1968-2007
Reply With Quote
  #9  
Old 22-07-2013, 12:00 PM
RCS2810 RCS2810 is offline
BANNED USER
  
Join Date: Jun 2013
Location: Fuel Station
Posts: 330
Default
Quote:
Originally Posted by Anger View Post
If the fans cut in its not normally a blockage
Ah okay. Learn something new every day.
Reply With Quote
  #10  
Old 22-07-2013, 12:55 PM
Anger's Avatar
Anger Anger is offline
Platinum Member
  
Join Date: Oct 2008
Location: Bletchingley Surrey
Posts: 4,973
Default
Take it for a drive without any boost and see if it still does it, if not then drive on boost, if it does then I would say HG
__________________
"We're here for a good time, not a long time...." Colin McRae MBE 1968-2007
Reply With Quote
  #11  
Old 22-07-2013, 01:38 PM
Lucky's Avatar
Lucky Lucky is offline
'2 Spanners Qualified Technician' - If your job requires more then 1 spanner I'm your man !!!!!
  
Join Date: Sep 2008
Location: Telscombe Cliffs
Posts: 5,062
Default
Ok, I took the rad cap off, put heater on full, hot and screen and just left it ticking over with the occasional throttle blip.

When it was first started there where bubbles/air in the header tank, after about 5 mins this settled down and the only time i got bubbles was if i blipped the throttle. Sat like this for about 20 mins until eventually the level rose and started pushing water out of the top of the header tank when I then switched off.

Temp gauge read normal (just under half way)

Fans didn't cut in at all - even after 20/25 mins. I saw them working about 4 weeks ago but maybe it didn't get hot enough this time to activate them?.

Top rad hose very hot, bottom stone cold. (just checked again and its warm?)
__________________
10 Years of Scoobies:04 WRX SL, 06 HAWK STI, 97 JDM WRX STI WAGON, 05 WRX STI, MK3 FOCUS RS, now Porsche Cayman S
Last edited by Lucky; 22-07-2013 at 02:15 PM.
Reply With Quote
  #12  
Old 22-07-2013, 02:15 PM
Lucky's Avatar
Lucky Lucky is offline
'2 Spanners Qualified Technician' - If your job requires more then 1 spanner I'm your man !!!!!
  
Join Date: Sep 2008
Location: Telscombe Cliffs
Posts: 5,062
Default
Just been out to Newhaven, so about a 10 mile round trip, bit of bubbling in the expansion and top and bottom hoses now hot.

Think I'll just take it easy in it and see what Brent thinks on 8th.
__________________
10 Years of Scoobies:04 WRX SL, 06 HAWK STI, 97 JDM WRX STI WAGON, 05 WRX STI, MK3 FOCUS RS, now Porsche Cayman S
Last edited by Lucky; 22-07-2013 at 03:12 PM.
Reply With Quote
  #13  
Old 22-07-2013, 03:37 PM
andy-m's Avatar
andy-m andy-m is offline
Silver Member
  
Join Date: Apr 2010
Location: SE London
Posts: 1,148
Default
Quote:
Originally Posted by Lucky View Post
.....Top rad hose very hot, bottom stone cold. (just checked again and its warm?)
Maybe you have a sticky thermostat. it's under the housing where the bottom rad hose attaches.
In the big scheme of things, it's cheap to change so may be worth doing anyway just to eliminate it
Reply With Quote
  #14  
Old 22-07-2013, 03:59 PM
RCS2810 RCS2810 is offline
BANNED USER
  
Join Date: Jun 2013
Location: Fuel Station
Posts: 330
Default
Yeah it's not hard to change. Unless it could of been an air lock if you say the bottom hose is now hot after you got the air lock out?
Reply With Quote
  #15  
Old 22-07-2013, 06:39 PM
simba's Avatar
simba simba is offline
Silver Member
  
Join Date: Feb 2010
Location: horam
Posts: 1,451
Default
BRENT mate thats your answer you know it makes sense
__________________
1998 wrx wagon, RB5 , ..........
Reply With Quote
  #16  
Old 22-07-2013, 08:04 PM
Lucky's Avatar
Lucky Lucky is offline
'2 Spanners Qualified Technician' - If your job requires more then 1 spanner I'm your man !!!!!
  
Join Date: Sep 2008
Location: Telscombe Cliffs
Posts: 5,062
Default
Yep Sim, its booked in for a service, MOT etc on 8th august. I was just trying to sort this out before the meet on Saturday. Oddly it seems a bit better after what I did this morning.

I think it may be air tho, I gave the bottom pipe a squeeze tonight with the rad cap off and a huge gulp of air came out.
__________________
10 Years of Scoobies:04 WRX SL, 06 HAWK STI, 97 JDM WRX STI WAGON, 05 WRX STI, MK3 FOCUS RS, now Porsche Cayman S
Reply With Quote
  #17  
Old 22-07-2013, 08:08 PM
simba's Avatar
simba simba is offline
Silver Member
  
Join Date: Feb 2010
Location: horam
Posts: 1,451
Default
hope you get it sorted mate let me know if you need a lift in the truck or anything lol
__________________
1998 wrx wagon, RB5 , ..........
Reply With Quote
Reply

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 



All times are GMT +1. The time now is 05:47 PM.

Contact Us - SouthEastScoobies - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.

Opinions expressed are not necessarily the opinions of SouthEastScoobies or any individuals directly or indirectly involved in this website. No responsibility is taken or assumed for any comments or statements made on this or any associated website. Visitors who use this website and rely on, or act on any information do so at their own judgement, discretion and or risk. SouthEastScoobies or its content providers shall not be liable for any loss or damage arising from or otherwise in connection with your use of SouthEastScoobies forums. It is not possible for the Administrators of these forums, or the Moderators participating, to fully and effectively monitor Messages that are submitted for infringement of third party rights. If you believe that any information within the forums infringes your legal rights, or gives cause for concern you should notify an Administrator or a Moderator immediately giving such information to enable the recipient to amend, delete or remove in its entirety the message, at their earliest convenience.