|
|
#1
03-06-2016, 09:47 PM
|
||||
|
||||
3 Bar MAP sensor
After my mapping session today it appears that if I am to up the boost at all I need a 3bar map sensor as it's unsafe to map over 1.6 bar on the OE sensor as you are too close to the sensors limits - does anybody know if there is an PnP sensor for a 2002 WRX or am I going to have to go for a generic sensor?
__________________
2005 Spec B 6MT - KiDO tuned (~270Bhp)
Custom exhaust - Cosworth filter - Samco Intake - Tints - Bilstein B8/B6 & STI springs - SuperPro ALK - Whiteline positive shift kit, rack mounts, rear adjustable camber bushes, front ARB mounts & strut brace, 20mm rear ARB with AVO mounts, - Hardrace Gearbox and pitch mounts - Prodrive PFF7's - Front Brembos - Kenwood CarPlay - 1/2 carbon grille - STI front splitter 
|
|
#2
03-06-2016, 09:51 PM
|
||||
|
||||
|
You would have to rescale your sensor calibration in the ECU regardless of which one you fit, if that's at all possible (not over familiar with your ECU).
Ginola deleted OE boost control and went ACVR as a work-around.
|
|
#3
03-06-2016, 09:53 PM
|
||||
|
||||
|
There's no issue with the ECU side although obviously it needs to be mapped in after fitting, I was hoping for a physical PnP sensor to avoid making the engine bay any more of a mess! All the ones I've found are 2004 onwards and I think look different in design to mine.
__________________
2005 Spec B 6MT - KiDO tuned (~270Bhp)
Custom exhaust - Cosworth filter - Samco Intake - Tints - Bilstein B8/B6 & STI springs - SuperPro ALK - Whiteline positive shift kit, rack mounts, rear adjustable camber bushes, front ARB mounts & strut brace, 20mm rear ARB with AVO mounts, - Hardrace Gearbox and pitch mounts - Prodrive PFF7's - Front Brembos - Kenwood CarPlay - 1/2 carbon grille - STI front splitter
|
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
