Quote:
Originally Posted by 2-jaffacake-tone
hows the build getting on mate?
|
Very slowly LOL, went to cheam motors the other day to order the left side rocker cover gasket, inlet manifold gaskets and the rubber o-ring seals for in the middle of the block. The conrods are also on the crank so thats ready to go. I also measured the gaps between the cam lobes and tappets and hopefully figure out correct sizes, it does get a little confusing. Are these the correct gaps 0.20 for the Inlet and 0.25 for the exhaust... Because i noticed that on the info i have it says that upto 98 they are self adjusting (hydrolic) and they don't look like they are...
Its all scary stuff, i just hope it works at the end....
