[Mortster]

Hazzah!!

Almost...

Changed the temp sensor over, and was still getting the same codes. So I decided to check the manifold loom. So off came the manifold. Becomes apparent that the last owner was not good at wiring...The loom had been split apart, then tapped back up. Bare/Fraying wires all over the place.

Also, the manifold gaskets were shot!

Changed the gaskets over, put a new temp gauge sensor in aswell while it was all off and easy to do.

Took the loom of the broken engine, as I wont need it for R1GNO anyway, wrong version.

Put it all back together, replacing any other bodge jobs ( why to people do it? )

Waited for it to stop raining, went out for a quick spin. 21 and 23 now gone. So the above was needed.

But...33. Now know why, speedo has stopped working! Doh.

Upper cable is fine, spins the clock if you do it with your fingers, so its the lower half. Which is a PITA to get out.

Next weekend then....