I guess the converter has RCA sockets on the output side, if you plan to use the converter then connect the wires to the speaker outputs on the H/U before any crossovers etc.
The outputs using RCA's then go to the amp on the low level inputs section (channels 1 & 2), effectively fitting the converter 'inline'.
Or if you are not using the converter run speaker cables from the H/U speaker outputs to the amp, use the white connector block you should have got with the amp to connect these to the Amp, again channels 1 & 2.
The speaker leads go straight from the output side to the speakers/crossover. If you're not running a sub make sure you set filters to off.
__________________
2005 Spec B 6MT - KiDO tuned (~270Bhp)
Custom exhaust - Cosworth filter - Samco Intake - Tints - Bilstein B8/B6 & STI springs - SuperPro ALK - Whiteline positive shift kit, rack mounts, rear adjustable camber bushes, front ARB mounts & strut brace, 20mm rear ARB with AVO mounts, - Hardrace Gearbox and pitch mounts - Prodrive PFF7's - Front Brembos - Kenwood CarPlay - 1/2 carbon grille - STI front splitter
|