Bugeye Sti oil preasure.
 

Re: Bugeye Sti oil preasure.
 

500rpm bit low for tick over isnt it :?:
between 2-3 bar with 10/50w at 80c is good.

Re: Bugeye Sti oil preasure.
 

Found this. Mine at 500rpm is 1.5bar @ 3000rpm its over 5bar so no worrys :yeah
--------------------------------------------------------------------------------
#8 (permalink)

I have copied the following directly from the Subaru wkshop manual.

BTW (14.5 psi = 1 Bar)



Start the engine, and then measure the oil pressure.

Oil pressure:

98 kPa (1.0 kg/cm2, 14 psi) or more at 800 rpm
294 kPa (3.0 kg/cm2, 43 psi) or more at 5,000
rpm

• If the oil pressure is out of specification, check oil
pump, oil filter and lubrication line. <Ref. to
LU(H4DOTC)-21, INSPECTION, Engine Lubrication
System Trouble in General.>
• If the oil pressure warning light is turned ON and
oil pressure is in specification, replace the oil pressure
switch. <Ref. to LU(H4DOTC)-21, INSPECTION,
Engine Lubrication System Trouble in
General.>
NOTE:
The specified data is based on an engine oil temperature
of 80°C (176°F).
5) After measuring the oil pressure, install the oil
pressure switch. <Ref. to LU(H4DOTC)-18, INSTALLATION,
Oil Pressure Switch.>
Tightening torque:
25 N·
: