South East Scoobies

South East Scoobies (http://www.southeastscoobies.co.uk/vbulletinforum/index.php)
-   General Car / Scooby Chat (http://www.southeastscoobies.co.uk/vbulletinforum/forumdisplay.php?f=17)
-   -   Mapping (http://www.southeastscoobies.co.uk/vbulletinforum/showthread.php?t=19710)

wheelspin 20-02-2015 06:18 PM

Mapping
 
I want to get my map tweaked, any recommendations in West Sussex?
Thanks in advance,
Nick

Ginola 20-02-2015 06:53 PM

Richard @ FB Tuning (number in my sig) or Duncan Race Dynamix , or travel further afield.

:welcome: to SES fella :)

wheelspin 20-02-2015 11:31 PM

Thanks Ginola, Just finally after 5 months [after buying the car] got it up and running after an engine rebuild, [ hence the re map] What a car, should have got one of these years ago, its an absolute missile down a bendy road !

Hongkongfooi 21-02-2015 12:49 PM

Bob rawle is in swindon but may travel over:doubleup:

Security_Paul 23-02-2015 11:14 AM

Duncan @ RaceDynamix looks after my maps.

jmcc42uk 23-02-2015 03:52 PM

Wayne @ Chipwizards

555_Si 23-02-2015 05:50 PM

Neil at Slowboy, Brands Hatch. To be honest I don't think you'll find s good Subaru mapper on your doorstep, Duncan at Racedynamix goes to Surrey Rolling Road at Farnborough.

tommy_v 23-02-2015 07:54 PM

I had good results from Duncan @ racedynamics too. he travelled out and did it at my work in Henfield.

Mike j 23-02-2015 09:53 PM

I used Duncan aswell. Very happy with the results.

wheelspin 26-02-2015 11:46 AM

I wanted someone with a rolling road, i want to keep the power down to save the gearbox.
Im assuming if its mapped on the road they wont know what power is being produced?

C. J. 26-02-2015 11:56 AM

Duncan is at surreyrollingroad every Friday

wheelspin 26-02-2015 02:09 PM

Ok, thanks

Security_Paul 26-02-2015 04:47 PM

Normally every Thursday and Friday nowadays. Check his website and it'll tell you when he's there.

Give me a shout if you head there, I'm a few minutes round the corner from it and will pop over.

Ginola 26-02-2015 07:03 PM

Quote:

Originally Posted by wheelspin (Post 203915)
I wanted someone with a rolling road, i want to keep the power down to save the gearbox.
Im assuming if its mapped on the road they wont know what power is being produced?

All methods are not exact, but the rollers is the more accurate measurement method! :)
I personally prefer a road map, as I don't drive my car on a rolling road.. then if needed or you want bragging rights, then a tweak on the dyno.

In an ideal world we would map in 6th on the autobahn! up hill with bricks in the back :P

Not a Diesel!!! 03-03-2015 08:37 PM

What's the story on Fuel Pumps & other uprated parts?

How closely do you need to fit them before the Map? Will it cause damage to fit in advance.

Can you take it somewhere & get them to fit the pump & the map at the same time?

Steve_PPP 04-03-2015 09:35 AM

Fuel pump can be changed whenever you like, its not going to cause damage running an upgraded pump without mapping the car.

Other uprated parts.... well it depends what parts ;)

Scott.T 04-03-2015 09:27 PM

If you have Polo's in the glovebox you should really consider a remap.

But if you swap them for mento's....!!!!!!
Have you seen what they do to a bottle of coke !!!!!
I would suggest you drive off-boost until you can get to a dyno.

Ginola 05-03-2015 12:32 AM

Quote:

Originally Posted by SilverSurfer (Post 204047)
If you have Polo's in the glovebox you should really consider a remap.

But if you swap them for mento's....!!!!!!
Have you seen what they do to a bottle of coke !!!!!
I would suggest you drive off-boost until you can get to a dyno.


I have!!! this is what happens!! .. better if you add Nutella and crazy Italian guy aswell!

http://www.youtube.com/watch?v=59L51yWUFiQ

Steve_PPP 05-03-2015 09:33 AM

:rofl:

Only on here..... could a thread go from a genuine mapping questions to coke and durex in two posts :D


All times are GMT +1. The time now is 09:26 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.